DOUBLE BEADSMITH 20.3cm bead mill, jewelry making tools, weaving, seed beads, x1 - G8755

The bead mill is a handy tool for jewelers who want to quickly and easily thread beads onto a wire. This bead mill duo features curved needles for threading beads.

This is a handy tool for stringing beads . It allows the beads to rotate smoothly, making it easier to thread them onto a wire.

In summary, the bead mill is an essential tool for jewelers looking to quickly string their seed beads.

Directions for use:
Before you begin, make sure you're working on a flat surface. Measure your wire so it's 10 cm longer than the length of the beads you need.

To use the tool, thread the needle and tie a knot in the end, or leave it attached to the spool of thread.
To prevent your yarn from tangling, tuck the short end between the folds of the long end.
Pour the pearls into the bowl, filling them halfway. Rotate the center of the mill with one hand, but not too quickly or the pearls may fly out.
With your other hand, place the curved end horizontally into the beads near (but not touching) the outer wall of the right side of the bowl. The beads will quickly load onto the needle.
Once you have a few inches of beads on the needle, carefully lift the curved end, then thread the beads onto the wire.
Repeat the entire spinning and twisting process until you reach the desired bead length.

Tray length: 20.3cm
Height: 10.15cm
Diameter of each mill: 9.52cm
Cover: 8.25cm
Curved needle length: 7.6cm

Material: wood

Comes with two curved needles and a cover

Need help?
If you're a beginner, don't panic! We'll give you tips and advice to learn the basics of DIY costume jewelry creation: https://www.gingerlilyperles.fr/blogs/nos-tutorials

Other tools for jewelry creation are available on our website Gingerlily.fr

Presentation suggestions, non-contractual photos.